Configure Cisco Router PPP over Ethernat With NAT

Post# A568583 · Los Angeles, California · Posted by: sparrow.jack5719

Cisco Router can be configured with point-to-Point over Ethernet (PPPoE) interfaces with Network address Translation (NAT). and A PPPoE session is initiated on the client at Cisco 819, Cisco 860, or Cisco 880. NAT signifies two addressing domains and the inside source address. The source list defines how the packet travels through the network. for the faster Ethernet setup dialer Interface or setup WAN Interfaces. if you are unable to configure the Ethernet on Cisco router. then you can solve this problem by calling at Cisco router support number +1-800-953-0960, our best technicians will help you to configuration Ethernet on Cisco Router.

Visit: http://www.ciscoroutercustomercarephonenumber.com - http://www.ciscoroutercustomercarephonenumber.com


Contact this User

It is ok to contact this poster with commercial interests.
Maximum file size: 200KB
captcha
Enter the code shown above into this textbox